Configure VLAN on Cisco Network Device(Part I)

Recently,I am studying Cisco network technology due to my job will touch some network knowledge. Since go to the present corporation, I have no chance to touch any network skill when someone is the ownership of network engineer. I have to wake up some memory from network lab by myself.

First lab, How to configure VLAN on Cisco Switch & Router?

To search some article by Google and study some network book,the following steps are my lab experience for your reference.

Isolation Between Two Layer 2 VLANs on Switch(refer to Cisco)

A Layer 2 VLAN is the VLAN created in the switch and not configured with the interface vlan command. Hosts in the different Layer 2 VLANs cannot communicate with each other.

(1).Configure Switch by Console

• Enter global configuration mode

1.Add vlans to the vlan database(VLAN Configuration in VLAN Configuration Mode)

2.Configure a trunk port for Router

3.Assigning Static-Access Ports to a VLAN  for PC1 or PC2

(2).Configure Router by Console

1.Add vlan entries to the vlan database

2.Enable the f0/0 interface

3.Configure Subinterfaces for each vlan

4.Confirm IP and VLAN Setup

5.Write Down Database

(3).Set network parameter on PC1 and PC2
Configure PC1
IP address: 192.168.1.2   Subnet Mask:255.255.255.0    Gateway:192.168.1.1

Configure PC2
IP address: 192.168.2.2   Subnet Mask:255.255.255.0    Gateway:192.168.2.1

(4).Test IP Connectivity between PC1 and PC2 by ping command